Angler Anchor Winches feature Touch and Release TRAC AutoDeploy. With the touch of a button (press and release), the anchor is powered down smoothly and quietly, while you go about your boating activity. When the anchor reaches bottom, the winch will transition from steady power-deploy and begin releasing rope just a few feet at a time, until the there is enough rope out, then the winch will "lock" holding the boat position. You can always let more rope out by powering the rope IN or OUT. Or, press the AutoDeploy button again if the anchor drags due to changing conditions, such as wind or current.
Push-button AutoDeploy which automatically deploys the anchor
Automatically releases the rope needed to hold the boat in position
CPX deck unit features an alloy base. New styling and architecture has reduced the number of parts without compromising on performance, and makes the windlass easier to service. Kit includes: Deck unit, motor gearbox, gypsy, solenoid, circuit breaker and Rocker switch
Automatically raise or lower your anchor. 12 volt operation. Special anti-drag system senses bottom to allow for controlled drifting. Then, at the touch of a button, lock the winch to prevent drifting. Anchor not included. DH-25: Pre spooled with 60' of 800 lb test nylon rope. Includes remote mountable anchor davit. Consistent hole pattern with older DeckHand models.
Easily install your anchor winch, trolling motor and other accessories from the top of your boat deck - great when you can't reach under the deck! Protects your boat from vibrations. Marine-grade 316 stainless steel bolts are easily installed in a 1/2" hole with Phillips head screwdriver. For accessory frames up to 1-1/8" thick.